Plumber in Bondi Junction

We provide upfront, fixed pricing, quoted and agreed before any work begins. Every job is different, so we assess, explain, and quote before we touch a tool. No surprises on the invoice, and we'll work with you to find the best-value repair that meets your needs and budget.

No callout fee during business hours. For after-hours emergency calls, we explain any callout fee on the phone so you can decide whether to go ahead.

We're based on Berwick Street in Coogee. For emergencies, we aim to be on-site within 30 minutes of Bondi Junction. For standard jobs, we'll book you in same-day or next-day.

Multi-floor stack blockages in high-rise buildings need a different approach to a standard house drain. The blockage is usually in the common sewer stack rather than in any individual lot, which makes it a strata matter. We attend, run a CCTV camera down the stack from the nearest roof or floor access point to locate the blockage precisely, then jet it clear. Once the immediate issue is resolved, we provide a strata-format report with CCTV footage showing the cause and the stack's general condition, so the committee can see whether this was a one-off or the start of a pattern that needs remediation. For centralised stacks in 1960s-80s Bondi Junction high-rise, partial relining of deteriorating sections is often the medium-term fix.

Centralised hot water plant failure affecting multiple lots is a strata emergency and we treat it as one. We attend, assess whether the failure is a single failed component (element, thermostat, pump) that can be repaired on the spot to restore service, or whether the plant is at end of life and needs staged replacement. If it's repairable, we do the repair and restore hot water, then provide the committee with a condition report and a replacement quote for their forward planning. If it needs replacement, we can supply and install while coordinating with the strata manager to notify residents, and we aim to minimise the number of consecutive hours without hot water across the building.

Multi-floor leaks in high-rise buildings are some of the most complex leak detection jobs because water travels through wall cavities, concrete floor slabs, and service ducts before appearing at the ceiling below. We work upward from the lowest visible damage point, using thermal imaging to map the moisture path through the building fabric, and acoustic equipment to listen for the water movement at the source. In most cases the source traces to either a wet area failure (shower base, bath seal) in a lot above, a common drain stack leak inside a wall cavity, or a supply line failure in the intertenancy ceiling space. We document our finding clearly so the right party, whether the upstairs lot owner or the strata, can organise the repair.

Yes. Gas compliance certificates for commercial tenancies are a standard part of what we do. Bondi Junction's commercial precinct has a mix of food and hospitality tenancies, retail fit-outs, and mixed-use residential above, and compliance requirements differ between them. For food-service tenancies, we check all appliance connections, test the supply line for leaks, inspect rubber hose expiry dates and burner condition, and issue a certificate once everything passes. Timing can be coordinated around trading hours. We provide all documentation in the format required by the building owner, insurer, or council.

Yes. Bulk maintenance for large Bondi Junction strata schemes is something we're set up for. The typical approach is a scheduled common-area maintenance visit for all shared facilities (lobby toilets, car park amenities, gym bathrooms if applicable), with a separate process for lot-level work invoiced to individual owners on request or coordinated through the strata manager. For large schemes, we can set a fixed rate per lot per visit for standard tap and toilet maintenance items so the committee has predictable maintenance costs. All work is documented with before-and-after photos and written reports in committee format.

Relining a common sewer stack in a high-rise is more involved than a ground-level job but the principles are the same. We access the stack from inspection points at each floor or from the roof, run CCTV to confirm the sections that need relining and ensure the pipe is a suitable candidate (not fully collapsed), and install the cured-in-place liner section by section. Residents have continuous toilet and sink use throughout, with a few hours of waste system downtime per floor section during the actual cure. We coordinate with the strata manager to give residents notice and minimise disruption. The relined stack has a seamless interior and a design life of 50-plus years from the date of installation.

Turn off the water at the unit's isolation valve immediately. In high-rise apartments this is typically in the laundry or behind an access panel. If tenants can't locate it quickly, turn off the floor isolation valve in the common corridor, then call us. We attend, repair the burst flexi hose, restore water, and assess the extent of water damage for insurance documentation. In high-rise buildings a burst flexi hose can affect the unit below, so we coordinate access with the strata manager where needed. We check the age of all other flexi hoses in the unit before leaving, because a burst in one hose means the others are likely the same age and should be replaced.

For large Bondi Junction strata schemes, an annual maintenance program typically covers: common sewer stack CCTV inspection to track condition and catch deteriorating sections early; common hot water plant servicing if the building has centralised hot water; backflow prevention device testing, which is a legal requirement for commercial and mixed-use buildings; stormwater drainage clearing for car parks and common areas; and a condition report for the committee. We provide the full program at a fixed annual price based on the building's size and plumbing complexity, with a written report after each visit. For schemes with multiple buildings, we coordinate to complete all buildings in a single scheduled block where practical.

Yes, at the lot level. Building-level filtration on the common water main requires strata committee approval and is typically impractical in a large high-rise. For individual apartments, we install a point-of-entry filter on the lot's water supply, usually in the laundry or inside a kitchen wall where water enters the unit. It delivers the same multi-stage filtration as a whole-home system but sized for one apartment's flow rate. Space is the main variable in high-rise apartments, so we assess what's available during the on-site quote and confirm the filter and housing fit before committing. The installation typically takes a couple of hours.

Tree roots are the number one cause of blocked drains in the Eastern Suburbs. We clear the roots with high-pressure jetting, then use CCTV to check if the pipe is damaged. If it is, we can reline it without digging up your yard.

Every 5 years. A 2025 Suncorp study of more than 22,000 claims found burst flexi hoses cause around 1 in 10 household water damage claims, with the average repair bill over $27,500. Check the date stamp on yours.