Water Filtration in Clovelly

The mains water supply from Sydney Water is consistent regardless of how close you are to the beach. What varies is the condition of your internal pipework. Homes closer to the coast tend to have faster corrosion on internal copper and galvanised pipes from salt air exposure, which means more sediment and particles in the water at your taps. A Puretec FilterWall installed at the point of entry catches this particulate before it reaches any fixture in the house.

Yes. The FilterWall installs on the water main after the meter, so it goes wherever the main enters the property. On steep Clovelly blocks where the meter is at the street level below the house, the unit typically mounts on an external wall near the meter or at the point where the main rises up to the house. We assess the best mounting location during the on-site quote, considering access for cartridge changes and protection from weather.

Whether you need whole-home filtration in Sydney depends on your house, not just the water. Sydney Water uses chlorine as its primary disinfectant, and most people taste it. Older Eastern Suburbs homes built before 1985 also shed sediment and rust from ageing copper or galvanised pipework. If you've noticed chlorine taste, white scale or discoloured water after a mains-off event, a whole-home filter solves it at every tap.

Whole-home Puretec FilterWall installs in Clovelly are quoted on-site after we assess your property and existing mainline setup. No callout fee. Fixed pricing, agreed before any work begins. Final cost depends on access, distance from the main, whether a pressure-limiting valve is needed, and any pre-filter mainline work. Both Stage 1 and Stage 2 cartridges are included in every install.

An under-sink filter cleans water at one tap, usually the kitchen sink. A whole-home filter cleans every tap, every shower, the washing machine and the toilets. For older Sydney homes where sediment damages appliances and chlorinated water dries skin in the shower, whole-home is the better answer. Under-sink is cheaper upfront but only solves the drinking-water problem.

Yes. Sydney tap water meets Australian Drinking Water Guidelines and is safe to drink straight from the tap. People fit filters for taste, smell and sediment, not safety. Sydney Water uses chlorine for disinfection (not chloramine), and most people can taste it. Older Eastern Suburbs pipework can also add sediment. A whole-home filter removes both.

The Puretec FilterWall is a two-stage system. Stage 1 is a pleated sediment cartridge (5-micron) that catches sand, rust, silt and pipe-shed particles common in older Eastern Suburbs homes. Stage 2 is an activated carbon block that removes chlorine taste and odour, plus chemical residues like pesticides and trace VOCs. It does not soften hard water. That's a different system.

Cartridge life depends on your water and household size. As a guide: the Stage 1 sediment cartridge needs replacing every 6-12 months (sooner if water is visibly dirty or after mainline work), and the Stage 2 carbon cartridge every 12-15 months. Most Eastern Suburbs households on town water get a year out of both. We label your install date inside the door so you know.

The FilterWall mounts outside, near where your water main enters the house, usually on a structural wall or post under cover, shaded from direct sun. The housing is a registered design (slimline grey or white) so it sits flush against fences or garage walls. Sydney mains pressure typically runs 500-600 kPa, so we fit a pressure-limiting valve if your home doesn't already have one.